GBAmp3 Mod PCB Order Now
also available at retromodding.comand Deadpan Robot

Saturday, February 18, 2012

Desk lamp leds retrofit with diy constant current driver

Continuing my previous post about diy constant current boost driver for 9 leds in series, here is a mod for my burned out desk lamp.
I've designed new schematics with 4 mosfets in parallel, because this is only mosfets I had on hands and they are pretty low power with high Rdson. So I decided to use as many as I can.
New schematics:

Then I tear my desk lamp apart, throw internals away except power switch and measured insides how to fit driver pcb.
With this measurments I designed new pcb:

As long as this driver can drive 9-18 leds in series I want to use 3 modules in parallel with 9 leds in series each.
Here is one module pcb assempled:

What diy project without hotglue? Hotglued new driver assempled pcb in place.

New design has push button to switch power modes from low light to max output light. So I drilled a hole to fit this button in. It's pretty invisible and handy to switch light output.

3 led modules glued in place of cfl bulb:

And now it shines my desk, well actually just wall behind my lcd monitor =)

Sorry forgot to picture the whole build.
This project is Open Source and Open Hardware as all what I'm doing here. So take a peek inside the sources and schematics at bitbucket.org and fork if you want.

No comments:

Post a Comment